mirror of
https://github.com/pascallanger/DIY-Multiprotocol-TX-Module.git
synced 2025-02-04 20:38:14 +00:00
18 lines
1.2 KiB
Markdown
18 lines
1.2 KiB
Markdown
# XN297L dump feature
|
|
|
|
To get the XN297L dump feature working on your module you must know:
|
|
1. How to buid the firmware from the source code available on this GitHub. To do so follow this page: [Compiling and programming the STM32 module](Compiling_STM32.md).
|
|
1. How to enable serial debug [MULTI-Module Serial Debug](Advanced_Debug.md).
|
|
|
|
Procedure to use the XN297L dump feature:
|
|
1. Start the Multi module in serial debug mode with the Arduion IDE Serial Monitor open<br> <img src="images/Serial_Monitor_2.png" />
|
|
1. Select the protocol XN297DP, 63 or "Custom 63" to enable the XN297L Dump protocol
|
|
1. This protocol parameters are:
|
|
* sub_protocol or type or the second number after "Custom 63" is used to set the transmission speed: 0=250Kbps, 1=1Mbps, 2=2Mbps and 3=Auto.
|
|
* Auto is the recommended mode since it gives many information like channels, timing, order as well as finding bytes meaning
|
|
* RX_num or Receiver number sets the address length 3, 4 or 5 bytes. Any other value will default to an address length of 5 bytes.
|
|
* option sets the RF channel number used to receive packets between 0..84 . A value of -1 will automatically scan all channels one by one. Any other value will default to the RF channel 0.
|
|
|
|
Examples:
|
|
TBC
|