4a626eaf14
Loads of protocols have been touched by this change. Some testing has been done but please test on all your models. The XN297 emulation selects in this order: - the CC2500 if it is available and bitrate=250K. Configure the option field automatically for RF tune. - the NRF for all bitrates if it is available - if NRF is not available and bitrate=1M then an invalid protocol is sent automatically to the radio. CC2500 @250K can now receive normal and enhanced payloads. OMP protocol supports telemetry on CC2500 and is also for NRF only modules including telemetry. Separation of E016H (new protocol) from E01X due to different structure. MJXQ, MT99XX, Q303 and XK: some sub protocols available on CC2500 only.
Multiprotocol TX Module OpenTX LUA scripts
If you like this project and want to support further development please consider making a donation.
 €5 |
€10 |
€15 |
€25 |
Other |
MultiChannelsUpdater
Automatically name the channels based on the loaded Multi protocol and sub protocol including the module channel order convention.
Need OpenTX 2.3.9 or above. Located on the radio SD card under \SCRIPTS\TOOLS. This script needs MultiChan.txt to be present in the same folder.
MultiLOLI
Script to set the channels function (switch, servo, pwm, ppm, sbus) on a LOLI RX
Graupner HoTT
Enable text configuration of the HoTT RX and sensors: Vario, GPS, ESC, GAM and EAM.
Need OpenTX 2.3.9 or above. Located on the radio SD card under \SCRIPTS\TOOLS.
Notes:
- Menu/MDL/Model is used to cycle through the detected sensors.
- It's normal to lose the telemetry feed while using the text mode configuration. Telemetry will resume properly if the script is exited by doing a short press on the exit button.
DSM Forward Programming
This is a work in progress. It's only available for color screens (Horus, TX16S, T16, T18...).
If some text appears as Unknown_xxx, please report xxx and what the exact text display should be.
Need OpenTX 2.3.10 nightly or above. Located on the radio SD card under \SCRIPTS\TOOLS.
DSM PID Flight log gain parameters for Blade micros
Lua telemetry script from feathering on RCGroups to facilitate setting the Gain Parameters on the Blade 150S FBL. It doesn't use Forward Programming but instead it just reads telemetry data from the Multi-module and displays it on a telemetry display.
It is very similar to the Telemetry Based Text Generator functionality on Spektrum transmitters where one doesn't need to rely on the angle of the swashplate to determine selection/value.