#Model Setup This is the page to document model or receiver specific setup instructions. The Deviation project (on which this project was based) have a useful list of models [here](http://www.deviationtx.com/wiki/supported_models). #Syma X5C ##Binding There are no special binding instructions. The model powers up in Autobind mode and expects the bind sequence from the transmitter within the first 4-5 seconds. ##Tx Setup A basic 4-channel setup works perfectly, but some improvements are possible: ###Setting up a switch to Flip ###Setting up a swich for high rates ###Setting up Idle-up One of the most annoying functions on the Syma X5C is that the motors stop when the throttle is pulled back. This can be fixed by implmenting Idle-up on the transmitter (think of this as a very simple version of the Betaflight "Air Mode"). Idle up will ensure that even when the throttle is all the way down, a minimum command is passed to the motor to keep them spinning and to activate the stabilization. To do this: 1. Decide on a switch you will use to activate Idle up 1. In the mixer menu add a line under Throttle and mix in a value of between 4 and 6 to be added to the throttle value if the switch is activated. What this does is effectively prevents the throttle from #Inductrix (Horizon Hobby) ##Binding {Enter bind instructions here - Which DSM mode works best?} ##Tx Setup {How to setup the transmitter optimally for leveling and acro mode}