DSMR timing

Multiprotocol/DSM_cyrf6936.ino

@@ -292,7 +292,7 @@ uint16_t DSM_callback()
 	#define DSM_CH1_CH2_DELAY	4010			// Time between write of channel 1 and channel 2
 	#ifdef STM32_BOARD
 		#define DSM_WRITE_DELAY		1600		// Time after write to verify write complete
-		#define DSM_READ_DELAY		400			// Time before write to check read phase, and switch channels.
+		#define DSM_READ_DELAY		300			// Time before write to check read phase, and switch channels.
 	#else
 		#define DSM_WRITE_DELAY		1950		// Time after write to verify write complete
 		#define DSM_READ_DELAY		600			// Time before write to check read phase, and switch channels.
@@ -470,15 +470,15 @@ uint16_t DSM_callback()
 		case DSM_CH2_READ_B:
 			//Read telemetry
 			rx_phase = CYRF_ReadRegister(CYRF_07_RX_IRQ_STATUS);
-			debug("ST1:%02X ",rx_phase);
+			//debug("ST1:%02X ",rx_phase);
 			if((rx_phase & 0x03) == 0x02)  					// RXC=1, RXE=0 then 2nd check is required (debouncing)
 				rx_phase |= CYRF_ReadRegister(CYRF_07_RX_IRQ_STATUS);
-			debug("ST2:%02X ",rx_phase);
+			//debug("ST2:%02X ",rx_phase);
 			if((rx_phase & 0x07) == 0x02)
 			{ // good data (complete with no errors)
 				CYRF_WriteRegister(CYRF_07_RX_IRQ_STATUS, 0x80);	// need to set RXOW before data read
 				length=CYRF_ReadRegister(CYRF_09_RX_COUNT);
-				debug("RX(%d)",length);
+				//debug("RX(%d)",length);
 				if(length>TELEMETRY_BUFFER_SIZE-2)
 					length=TELEMETRY_BUFFER_SIZE-2;
 				CYRF_ReadDataPacketLen(packet_in+1, length);
@@ -496,7 +496,7 @@ uint16_t DSM_callback()
 				//	debug(" %02X", packet_in[i]);
 				telemetry_link=1;
 			}
-			debugln("");
+			//debugln("");
 			CYRF_WriteRegister(CYRF_29_RX_ABORT, 0x20);		// Abort RX operation
 			if (phase == DSM_CH2_READ_A && (sub_protocol==DSM2_1F || sub_protocol==DSMX_1F) && num_ch < 8)	// 22ms mode
 			{

Multiprotocol/Multiprotocol.h

@@ -19,7 +19,7 @@
 #define VERSION_MAJOR		1
 #define VERSION_MINOR		3
 #define VERSION_REVISION	4
-#define VERSION_PATCH_LEVEL	49
+#define VERSION_PATCH_LEVEL	50
 
 #define MODE_SERIAL 0
 

Multiprotocol/SGF22_nrf24l01.ino

@@ -49,7 +49,6 @@ Multiprotocol is distributed in the hope that it will be useful,
 #define SGF22_J20_FLAG_FIXHEIGHT		0x80
 
 #define SGF22_WRITE_TIME				1000
-//#define SGF22_HUB_TELEMETRY
 
 enum {
 	SGF22_DATA1,
@@ -193,9 +192,9 @@ uint16_t SGF22_callback()
 			{
 				uint8_t p_len = XN297_ReadEnhancedPayload(packet_in, SGF22_PAYLOAD_SIZE);
 				if(p_len == 3 && packet_in[0] == rx_tx_addr[2] && packet_in[1] == rx_tx_addr[3])
-				{//packets only received when battery is low: 00 0B 01
+				{//packets: 00 0B 00 -> 00 0B 01
 					telemetry_link = 1;
-					v_lipo1 = packet_in[2] ? 0 : 255;
+					v_lipo1 = packet_in[2] ? 0 : 255;	//2.9V for 1S, 7.0V for 2S
 				}
 				#if 0
 					debug("L %d ",p_len);

Multiprotocol/Validate.h

@@ -499,6 +499,7 @@
 	#undef V761_HUB_TELEMETRY
 	#undef FX_HUB_TELEMETRY
 	#undef XK2_HUB_TELEMETRY
+	#undef SGF22_HUB_TELEMETRY
 	#undef KAMTOM_HUB_TELEMETRY
 	#undef YUXIANG_HUB_TELEMETRY
 	#undef RLINK_HUB_TELEMETRY
@@ -545,6 +546,9 @@
 	#if not defined(XK2_CCNRF_INO)
 		#undef XK2_HUB_TELEMETRY
 	#endif
+	#if not defined(SGF22_NRF24L01_INO)
+		#undef SGF22_HUB_TELEMETRY
+	#endif
 	#if not defined(KAMTOM_NRF24L01_INO)
 		#undef KAMTOM_HUB_TELEMETRY
 	#endif
@@ -608,7 +612,7 @@
 		//protocols using FRSKYD user frames
 		#undef HUB_TELEMETRY 
 	#endif
-	#if not defined(HOTT_FW_TELEMETRY) && not defined(DSM_TELEMETRY) && not defined(SPORT_TELEMETRY) && not defined(HUB_TELEMETRY) && not defined(HUBSAN_HUB_TELEMETRY) && not defined(BUGS_HUB_TELEMETRY) && not defined(NCC1701_HUB_TELEMETRY) && not defined(BAYANG_HUB_TELEMETRY) && not defined(CABELL_HUB_TELEMETRY) && not defined(RLINK_HUB_TELEMETRY) && not defined(AFHDS2A_HUB_TELEMETRY) && not defined(AFHDS2A_FW_TELEMETRY) && not defined(MULTI_TELEMETRY) && not defined(MULTI_STATUS) && not defined(HITEC_HUB_TELEMETRY) && not defined(HITEC_FW_TELEMETRY) && not defined(SCANNER_TELEMETRY) && not defined(FRSKY_RX_TELEMETRY) && not defined(AFHDS2A_RX_TELEMETRY) && not defined(BAYANG_RX_TELEMETRY) && not defined(DEVO_HUB_TELEMETRY) && not defined(PROPEL_HUB_TELEMETRY) && not defined(OMP_HUB_TELEMETRY) && not defined(V761_HUB_TELEMETRY) && not defined(XK2_HUB_TELEMETRY) && not defined(FX_HUB_TELEMETRY) && not defined(KAMTOM_HUB_TELEMETRY) && not defined(YUXIANG_HUB_TELEMETRY) && not defined(WFLY2_HUB_TELEMETRY) && not defined(LOLI_HUB_TELEMETRY) && not defined(MLINK_HUB_TELEMETRY) && not defined(MLINK_FW_TELEMETRY) && not defined(MT99XX_HUB_TELEMETRY) && not defined(MULTI_CONFIG_INO)
+	#if not defined(HOTT_FW_TELEMETRY) && not defined(DSM_TELEMETRY) && not defined(SPORT_TELEMETRY) && not defined(HUB_TELEMETRY) && not defined(HUBSAN_HUB_TELEMETRY) && not defined(BUGS_HUB_TELEMETRY) && not defined(NCC1701_HUB_TELEMETRY) && not defined(BAYANG_HUB_TELEMETRY) && not defined(CABELL_HUB_TELEMETRY) && not defined(RLINK_HUB_TELEMETRY) && not defined(AFHDS2A_HUB_TELEMETRY) && not defined(AFHDS2A_FW_TELEMETRY) && not defined(MULTI_TELEMETRY) && not defined(MULTI_STATUS) && not defined(HITEC_HUB_TELEMETRY) && not defined(HITEC_FW_TELEMETRY) && not defined(SCANNER_TELEMETRY) && not defined(FRSKY_RX_TELEMETRY) && not defined(AFHDS2A_RX_TELEMETRY) && not defined(BAYANG_RX_TELEMETRY) && not defined(DEVO_HUB_TELEMETRY) && not defined(PROPEL_HUB_TELEMETRY) && not defined(OMP_HUB_TELEMETRY) && not defined(V761_HUB_TELEMETRY) && not defined(SGF22_HUB_TELEMETRY) && not defined(XK2_HUB_TELEMETRY) && not defined(FX_HUB_TELEMETRY) && not defined(KAMTOM_HUB_TELEMETRY) && not defined(YUXIANG_HUB_TELEMETRY) && not defined(WFLY2_HUB_TELEMETRY) && not defined(LOLI_HUB_TELEMETRY) && not defined(MLINK_HUB_TELEMETRY) && not defined(MLINK_FW_TELEMETRY) && not defined(MT99XX_HUB_TELEMETRY) && not defined(MULTI_CONFIG_INO)
 		#undef TELEMETRY
 		#undef INVERT_TELEMETRY
 		#undef MULTI_TELEMETRY

Multiprotocol/_Config.h

@@ -351,6 +351,7 @@
 #define KAMTOM_HUB_TELEMETRY		// Use FrSkyD Hub format to send telemetry to TX
 #define FX_HUB_TELEMETRY			// Use FrSkyD Hub format to send telemetry to TX
 #define XK2_HUB_TELEMETRY			// Use FrSkyD Hub format to send telemetry to TX
+#define SGF22_HUB_TELEMETRY			// Use FrSkyD Hub format to send telemetry to TX
 #define YUXIANG_HUB_TELEMETRY		// Use FrSkyD Hub format to send telemetry to TX
 #define PROPEL_HUB_TELEMETRY		// Use FrSkyD Hub format to send telemetry to TX
 #define CABELL_HUB_TELEMETRY		// Use FrSkyD Hub format to send telemetry to TX

Protocols_Details.md

@@ -2238,6 +2238,8 @@ CH1|CH2|CH3|CH4|CH5|CH6|CH7|CH8|CH9|CH10|CH11|CH12
 ---|---|---|---|---|---|---|---|---|---|---|---
 A|E|T|R|MODE|FLIP|LIGHT|PHOTO|VIDEO|TRIMRESET|BAL|BALHIG
 
+Telemetry is supported. The plane sends a battery status of good->empty which is visible in A1 (good=13.2V->empty=0V) and RSSI gets a dummy value of 100.
+
 ### Sub_protocol F22
 Model: SG F22