This feature will not activate the selected protocol unless a bind is
requested using bind from channel or the GUI "Bind" button. It is only
enabled if bind from channel and autobind are set since I think they are
working well together.
The goal is to prevent binding other people's model when powering up the
TX, changing model or scanning through protocols.
There is a new blinking pattern associated to it as well as a new status
"Waiting for bind".
This feature is enabled by default in _config.h .
This new feature is available:
- in serial mode and when binding from the GUI. As soon as the Bind
window is closed = serial bind bit was set and cleared, the current bind
operation will be terminated.
- if the bind was initiated from the Bind on channel feature (bind
channel goes high) then as soon as the bind channel goes low the current
bind operation will be terminated.
Tested on ersky9x which does open a bind window, not sure about
OpenTX...
Some protocols (Hubsan, Assan, FY326, Shenqi...) which are waiting for
model/RX to reply will stay in bind mode.
- rewritten the handling of the incoming over the air telemetry packet
- rewritten the TX_RSSI calculation (link frame[4])
- added RX LQI and TX_LQI information in the link frame (frame[5] and
frame[6])
WK2801 number 0, 8 channels, fixed id is not supported
WK2401 number 1, 4 channels
W6_5_1 number 2, 6 channels
W6_6_1 number 3, 7 channels
W6_HEL number 4, 6 channels, option is used to limit COL
W6_HEL_I number 5, 6 channels, COL inverted, option is used to limit COL
Protocol WK2x01 number 30
Sub protocols:
- WK2801 number 0, 8 channels, fixed id not supported
- WK2601 number 1, 6/7 channels, option is used see doc for details
- WK2401 number 2, 4 channels
Extended limits supported
Autobind protocol
Most receivers support WK2801 so always start trying this sub protocol
first.
Toggling channel 16 (-100%->+100%->-100%) will execute a bind only if
the loaded protocol is an autobind protocol or autobind is set AND
throttle is low (below -95%).
