* [Codex assisted] RadioLink / DumboRC command packages bridge
Pass "special" packages to and from the module
Allows to replicate "Set Failsafe", "Set Gyro Settings" and "Set Gyro Endpoints" from DDF-350
* RadioLink / DumboRC command packages TX / RX
* RadioLink / DumboRC Helper script channel names
Has max 10 channels
Has no failsafe
Older X series have gyro sense fixed to CH8, also can be used as regular channel
* [Codex] DumboRC P Series settings script
Add script that mimics interaction between DumboRC DDF-350 transmitter and P Series receivers
* [Codex assisted] Split P series into separate subprotocol
Split command exchange into separate subprotocol
Update protocol documentation
* [Codex] Improve LUA script
Clean up, better event handling
Loads of protocols have been touched by this change. Some testing has been done but please test on all your models.
The XN297 emulation selects in this order:
- the CC2500 if it is available and bitrate=250K. Configure the option field automatically for RF tune.
- the NRF for all bitrates if it is available
- if NRF is not available and bitrate=1M then an invalid protocol is sent automatically to the radio.
CC2500 @250K can now receive normal and enhanced payloads.
OMP protocol supports telemetry on CC2500 and is also for NRF only modules including telemetry.
Separation of E016H (new protocol) from E01X due to different structure.
MJXQ, MT99XX, Q303 and XK: some sub protocols available on CC2500 only.
Compatible model: PROPEL 74-Z Speeder Bike
Protcol: PROPEL (66)
Sub protocol: none
Autobind protocol
Extended limits not supported
Telemetry supported
14 channels in use due to many features
Rewrite of the FrSkyX code to support both v1 and v2.1.0 with FCC and LBT.
FrSky v1 accessible as usual
FrSky v2.1.0 accessible through the protocol 64=FrSkyX2 with the same subprotocols as v1
The LBT feature is now fully implemented on the TX and turned on for both v1 LBT and v2.1.0 LBT.
For v2.1.0, to access the bind functions Telem=on/off, CH1-8/9-16 and bidirectional SPort (SxR setup for example), you need to update OpenTX to the latest 2.3.8 nightly (not available yet).
XN297L@250kbps is emulated by default with the NRF24L01. If option (freq tune) is diffrent from 0, the CC2500 module (if installed) will be used instead with option being the freq usual tuning.
Failsafe MUST be configured once with the desired channel values (hold or position) while the RX is up (wait 10+sec for the RX to learn the config) and then failsafe MUST be set to RX/Receiver otherwise the servos will jitter!!!
Eduard
pascallanger
Michael
Pascal Langer
Ben Lye
Goebish