Models: MJX Bugs 3 Mini and 3H
Protocol BUGSMINI = 42
No sub_protocol
Telemetry = RX RSSI and battery voltage good/warning/bad
RX_Num is used to give a number to a given model. You must use a different RX_Num per MJX Bugs Mini. A maximum of 16 Bugs Mini are supported.
Channels:
ARM CH5
ANGLE CH6
FLIP CH7
PICTURE CH8
VIDEO CH9
LED CH10
Hitec protocol using the CC2500 RF component
Protocol number: 39
Sub protocols:
- Optima (0): the TX must be really close to the RX for the bind negociation to complete.
- Minima (1): untested
Optima supports basic telemetry using the FrSky Hub format: RX volt, TX RSSI,&LQI
Implemented debug output on uart1 for stm32
Replaced hardcoded eeprom offsets with documented constats
Fixed a bug affecting telemetry on Atmega328p using the invert_telemetry flag.
This feature will not activate the selected protocol unless a bind is
requested using bind from channel or the GUI "Bind" button. It is only
enabled if bind from channel and autobind are set since I think they are
working well together.
The goal is to prevent binding other people's model when powering up the
TX, changing model or scanning through protocols.
There is a new blinking pattern associated to it as well as a new status
"Waiting for bind".
This feature is enabled by default in _config.h .
- rewritten the handling of the incoming over the air telemetry packet
- rewritten the TX_RSSI calculation (link frame[4])
- added RX LQI and TX_LQI information in the link frame (frame[5] and
frame[6])
This allows the multi module to tell the TX software (e.g. OpenTX) which telemetry protocol is in use. Also Status of the module and signaling binding/invalid protocol
