Spektrum own remotes transmit normal values during bind and actually use this (e.g. Nano CP X) to select the transmitter mode (e.g. computer vs non-computer radio, so always end normal output
This feature will not activate the selected protocol unless a bind is
requested using bind from channel or the GUI "Bind" button. It is only
enabled if bind from channel and autobind are set since I think they are
working well together.
The goal is to prevent binding other people's model when powering up the
TX, changing model or scanning through protocols.
There is a new blinking pattern associated to it as well as a new status
"Waiting for bind".
This feature is enabled by default in _config.h .
This new feature is available:
- in serial mode and when binding from the GUI. As soon as the Bind
window is closed = serial bind bit was set and cleared, the current bind
operation will be terminated.
- if the bind was initiated from the Bind on channel feature (bind
channel goes high) then as soon as the bind channel goes low the current
bind operation will be terminated.
Tested on ersky9x which does open a bind window, not sure about
OpenTX...
Some protocols (Hubsan, Assan, FY326, Shenqi...) which are waiting for
model/RX to reply will stay in bind mode.
- rewritten the handling of the incoming over the air telemetry packet
- rewritten the TX_RSSI calculation (link frame[4])
- added RX LQI and TX_LQI information in the link frame (frame[5] and
frame[6])
