Compatible model: PROPEL 74-Z Speeder Bike
Protcol: PROPEL (66)
Sub protocol: none
Autobind protocol
Extended limits not supported
Telemetry supported
14 channels in use due to many features
Rewrite of the FrSkyX code to support both v1 and v2.1.0 with FCC and LBT.
FrSky v1 accessible as usual
FrSky v2.1.0 accessible through the protocol 64=FrSkyX2 with the same subprotocols as v1
The LBT feature is now fully implemented on the TX and turned on for both v1 LBT and v2.1.0 LBT.
For v2.1.0, to access the bind functions Telem=on/off, CH1-8/9-16 and bidirectional SPort (SxR setup for example), you need to update OpenTX to the latest 2.3.8 nightly (not available yet).
XN297L@250kbps is emulated by default with the NRF24L01. If option (freq tune) is diffrent from 0, the CC2500 module (if installed) will be used instead with option being the freq usual tuning.
Failsafe MUST be configured once with the desired channel values (hold or position) while the RX is up (wait 10+sec for the RX to learn the config) and then failsafe MUST be set to RX/Receiver otherwise the servos will jitter!!!
* Add skeleton for AFHDS2A receiver protocol
* Bind & data Ok
* Send channels to TX via telemetry
* Add RSSI
* Fix AVR compilation
* Fix channel number
Models: MJX Bugs 3 Mini and 3H
Protocol BUGSMINI = 42
No sub_protocol
Telemetry = RX RSSI and battery voltage good/warning/bad
RX_Num is used to give a number to a given model. You must use a different RX_Num per MJX Bugs Mini. A maximum of 16 Bugs Mini are supported.
Channels:
ARM CH5
ANGLE CH6
FLIP CH7
PICTURE CH8
VIDEO CH9
LED CH10
Hitec protocol using the CC2500 RF component
Protocol number: 39
Sub protocols:
- Optima (0): the TX must be really close to the RX for the bind negociation to complete.
- Minima (1): untested
Optima supports basic telemetry using the FrSky Hub format: RX volt, TX RSSI,&LQI
