This feature will not activate the selected protocol unless a bind is
requested using bind from channel or the GUI "Bind" button. It is only
enabled if bind from channel and autobind are set since I think they are
working well together.
The goal is to prevent binding other people's model when powering up the
TX, changing model or scanning through protocols.
There is a new blinking pattern associated to it as well as a new status
"Waiting for bind".
This feature is enabled by default in _config.h .
WK2801 number 0, 8 channels, fixed id is not supported
WK2401 number 1, 4 channels
W6_5_1 number 2, 6 channels
W6_6_1 number 3, 7 channels
W6_HEL number 4, 6 channels, option is used to limit COL
W6_HEL_I number 5, 6 channels, COL inverted, option is used to limit COL
Protocol WK2x01 number 30
Sub protocols:
- WK2801 number 0, 8 channels, fixed id not supported
- WK2601 number 1, 6/7 channels, option is used see doc for details
- WK2401 number 2, 4 channels
Extended limits supported
Autobind protocol
Most receivers support WK2801 so always start trying this sub protocol
first.
Toggling channel 16 (-100%->+100%->-100%) will execute a bind only if
the loaded protocol is an autobind protocol or autobind is set AND
throttle is low (below -95%).
This allows the multi module to tell the TX software (e.g. OpenTX) which telemetry protocol is in use. Also Status of the module and signaling binding/invalid protocol
Protocol: MT99xx (number 17)
Subprotocol: FY805 (number 4)
Supports headless and flip. For flip I'm not sure of the flag since it
was missing from the dumps.
Untested protocol...
Changed telemetry configuration and validation for AFHDS2A and HUBSAN
Added default Bayang telemetry from Silverxxx:
- Option=1 to activate telemetry (option=0 -> standard Bayang protocol)
- Value returned to the TX: RX RSSI, TX RSSI, A1=uncompensated battery
voltage, A2=compensated battery voltage
Loads of changes:
STM32 board introduction: NOT TESTED
XMEGA renamed to ORANGE_TX to be more explicit
DSM: added reset if cyrf freezed
Validate: added a validate file to verify the different compilation
options
DSM sub_protocols are now:
- DSM2/1024@22ms
- DSM2/2048@11ms
- DSMX/2048@22ms
- DSMX/2048@11ms
Option=number of channels from 4 to 12 for normal receivers or -4 to -12
fro OrangeRX. An invalid option value will end up with 6 channels.
