Compatible model: PROPEL 74-Z Speeder Bike
Protcol: PROPEL (66)
Sub protocol: none
Autobind protocol
Extended limits not supported
Telemetry supported
14 channels in use due to many features
Rewrite of the FrSkyX code to support both v1 and v2.1.0 with FCC and LBT.
FrSky v1 accessible as usual
FrSky v2.1.0 accessible through the protocol 64=FrSkyX2 with the same subprotocols as v1
The LBT feature is now fully implemented on the TX and turned on for both v1 LBT and v2.1.0 LBT.
For v2.1.0, to access the bind functions Telem=on/off, CH1-8/9-16 and bidirectional SPort (SxR setup for example), you need to update OpenTX to the latest 2.3.8 nightly (not available yet).
Still work in progress
Subprotocols: X450 and X420 -> not sure if they are subprotocols or just different IDs...
CH5: M-Mode=-100%, 6G-Mode=0%, V-Mode=+100%
CH6: Take off momentary switch
CH7: Emergency stop momentary switch
CH8: 3D/6G momentary switch
CH9: Photo momentary switch
XN297L@250kbps is emulated by default with the NRF24L01. If option (freq tune) is diffrent from 0, the CC2500 module (if installed) will be used instead with option being the freq usual tuning.
* Add skeleton for AFHDS2A receiver protocol
* Bind & data Ok
* Send channels to TX via telemetry
* Add RSSI
* Fix AVR compilation
* Fix channel number
- Fixed DSM telemetry with some RXs (R720X)
- Global frequency tunning for all protocols using the CYRF6936 by adjusting channel 15 when enabled
- Changed default DSM_THROTTLE_KILL_CH to use channel 14
This layer can be enabled/disabled with the option XN297L_CC2500_EMU in _config.h
Protocols which are using it so far:
GD00X, KF606 and MJXQ/E010&PHOENIX
Protocol number: 48
Sub_protocol: none
Channel 5: +100% expert, 0% mid=gyro on no rate limits, -100% beginer=gyro on and axis rate limited.
ONLY 1 ID IS AVAILABLE SO BE CAREFUL WHILE FLYING.
Protocol number: 63
Sub protocols: 0=250Kb, 1=1Mb, 2=2Mb
Option: -1=scan RF channels, 0-84=RF channel
DEBUG_SERIAL must be enabled
If a valid frame is received the frame will be sent on the serial port.
