* Initial Version
* Bugfix and change of the handling of the RX Num.
If RX Num is 63, write a finetune value of 127 to the EEPROM.
A real finetune value of 127 means, the frequency of module is out of range and
the module should be replaced. This way the clone mode should not get unwanted
active by a module with a frequency drift arround 63.
Compatible model: PROPEL 74-Z Speeder Bike
Protcol: PROPEL (66)
Sub protocol: none
Autobind protocol
Extended limits not supported
Telemetry supported
14 channels in use due to many features
Rewrite of the FrSkyX code to support both v1 and v2.1.0 with FCC and LBT.
FrSky v1 accessible as usual
FrSky v2.1.0 accessible through the protocol 64=FrSkyX2 with the same subprotocols as v1
The LBT feature is now fully implemented on the TX and turned on for both v1 LBT and v2.1.0 LBT.
For v2.1.0, to access the bind functions Telem=on/off, CH1-8/9-16 and bidirectional SPort (SxR setup for example), you need to update OpenTX to the latest 2.3.8 nightly (not available yet).
- Change how PPM is handled with a resolution of 2048 and scaled to match serial input range. PPM is now fully scaled for all protocols which was not the case before. If you are using PPM, you might have to adjust the end points depending on the protocols.
- Change all range conversions to use 2048 where possible
- Updated all protocols with new range functions
- Protocols which are taking advantage of 2048 are Assan, FrSky V/D/X, DSM, Devo, WK2x01
- Renamed AUX xto CHx for code readbility
This new feature is available:
- in serial mode and when binding from the GUI. As soon as the Bind
window is closed = serial bind bit was set and cleared, the current bind
operation will be terminated.
- if the bind was initiated from the Bind on channel feature (bind
channel goes high) then as soon as the bind channel goes low the current
bind operation will be terminated.
Tested on ersky9x which does open a bind window, not sure about
OpenTX...
Some protocols (Hubsan, Assan, FY326, Shenqi...) which are waiting for
model/RX to reply will stay in bind mode.
