From b9b03fcd2ba792e766888230e64c6bbf3ced735e Mon Sep 17 00:00:00 2001 From: midelic Date: Mon, 1 Aug 2016 02:32:46 +0300 Subject: [PATCH] Delete Readme.txt --- PCB v2.3d/Readme.txt | 35 ----------------------------------- 1 file changed, 35 deletions(-) delete mode 100644 PCB v2.3d/Readme.txt diff --git a/PCB v2.3d/Readme.txt b/PCB v2.3d/Readme.txt deleted file mode 100644 index ee5a7e0..0000000 --- a/PCB v2.3d/Readme.txt +++ /dev/null @@ -1,35 +0,0 @@ -These are KiCad files and you are free to do what you will with them. KiCad is a good, free, and fairly -easy to learn. Build your own BOM and gerber files. - -This is a variant of the Multipro V2.3c circuit design. It is basicly the same as the 2.3c board as far -as component placement goes. What's changed is the added resistors for the serial protocol and also -the addition of solder jumpers on the bottom of the board for the various options to connect the TX, RX, and PPM -lines through them. See below for more detail. - -The schematic has been updated to reflect the added components and jumper pads as well as cleaned -up a little. As it sits now, the .net file loads without any complaints and DRC checks pass. - -The jumpers, and how they are used: - - -There are four solder type jumpers on the bottom side of the board near the lower left corner when the -bottom of the board is facing towards you. The silkscreen shows which jumper is which. These four jumpers -enable the board to be configured in several ways as explaned below. - - (J-1) Use (PPM V/V) if the incoming PPM signal is at a higher voltage level, leave open if ~~5V. - - (J-2) Use (Jumper 2) to connect the incomming PPM signal to the RX pin on the processor - - (J-3) Short (TELEM) only if you have done a telemetry mod to your radio, leave open if not needed. When - connected, pin 2 of the two pin header (P3) is also connected. - - (J-4) Use (MOD) only to connect the transmitter pin 2 to pin 1 of the two pin header (P3). - -The direction this project is going, it is most likely J-2 will be the only one needing to be shorted for -the serial method of sending model protocols. - - -These files are submitted without any guarentee of accureacy or suitability for any intended use. I am strictly -an amature with time on his hands. Although I have done all I know to make it correct, things outside of my -knowledge base are beyond my control. Do not use untested equipment around persons not familiar with the hazards -of remote controlled vehicals. \ No newline at end of file