From 7d04005c726250971131ea7f051e31af7c2e56fc Mon Sep 17 00:00:00 2001 From: pascallanger Date: Sun, 11 Feb 2018 14:40:07 +0100 Subject: [PATCH] Update PPM_Setup.md --- docs/PPM_Setup.md | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-) diff --git a/docs/PPM_Setup.md b/docs/PPM_Setup.md index 0989df9..9a8543b 100644 --- a/docs/PPM_Setup.md +++ b/docs/PPM_Setup.md @@ -32,19 +32,19 @@ The protocol selection is based on 2 parameters: - to go to the next bank, short press the bind button, this action is confirmed by the LED staying on for 1.5 sec Here is the full protocol selection procedure: - * turn the dial to 15 + * turn the selection switch to 15 * power up the module * the module displays the current bank by flashing the LED x number of times, x being between 1 and up to 5 * a short press on the bind button turns the LED on for 1 sec indicating that the system has changed the bank * repeat operation 3 and 4 until you have reached the bank you want * power off - * change the dial to the desired position + * change the selection switch to the desired position (1..14) * power on * enjoy Notes: * **The protocol selection must be done before the module is turned on** - * The protocol mapping based on bank+rotary switch position can be seen/modified at the end of the file [_Config.h](/Multiprotocol/_Config.h)** + * The protocol mapping based on bank + selection switch position can be seen/modified at the end of the file [_Config.h](/Multiprotocol/_Config.h)** ## Binding in PPM mode