Typo !!

docs/Compiling.md

@@ -16,32 +16,21 @@ The procedure below will guide you through all the steps to upload successfully
 ### Material you need to upload the firmware
 
 1. USBASP programmer supporting 3.3V:
-
 <img src="images/USBasp_Programmer.jpeg" width="200" height="200" />
-
 [(example aliexpress link)](https://www.aliexpress.com/item/USBasp-USB-ISP-3-3V-5V-AVR-Programmer-USB-ATMEGA8-ATMEGA128-New-10PIN-Wire-Support/2036402518.html?spm=2114.30010308.8.10.jIbHzs)
 There are reports that some of the cheap programmers are not safe to use with 3.3V units, usually the black PCB versions are ok.
-
 1. 10pin to 6pin adapter:
-
 <img src="images/10pin_2_6pin.JPG" width="150" height="150" />
-
 [(example ebay link)](http://www.ebay.fr/itm/10-Pin-a-6-Pin-Carte-Adaptateur-M-F-pour-AVRISP-USBASP-STK500-Noir-Bleu-WT-/291862396761?hash=item43f45abf59:g:gXsAAOSwMgdXyGnh)
-
 1. 6 pin header like this one:
-
 <img src="images/6pin_header.jpg" width="100" height="100" />
-
 [(example Digi-Key link)](http://www.digikey.com/products/en?keywords=3M%20961206-6404-AR)
-
-The 6 Pin header needs to be solder on the board like indicated by the red rectangle:
-* Banggood readymade 4-in-1 module:
+1.The 6 Pin header needs to be solder on the board like indicated by the red rectangle:
+   * Banggood readymade 4-in-1 module:
 <img src="images/V2b_ISP.jpeg" width="189" height="200" />
-
-* DIY Mulitprotocol modules (like the 2.3d board):
+   * DIY Mulitprotocol modules (like the 2.3d board):
 <img src="images/MPTM_PCB_2.3d_ISP.png" width="486" height="201" />
-
-* Arduino Pro Mini module:
+   * Arduino Pro Mini module:
 <img src="images/ProMini_ISP.png" width="195" height="200" />
 
 ### Connect the programmer