AFHDS2A sub protocols and validation

Multiprotocol/Multiprotocol.h

@@ -449,11 +449,11 @@ Serial: 100000 Baud 8e2      _ xxxx xxxx p --
 			FORMAT_HONTAI	0
 			FORMAT_JJRCX1	1
 			FORMAT_X5C1		2
-        sub_protocol==AFHDS2A
-        	FORMAT_IBUS+PWM 0
-        	FORMAT_IBUS+PPM 1
-        	FORMAT_SBUS+PWM 2
-        	FORMAT_SBUS+PPM 3
+		sub_protocol==AFHDS2A
+			PWM_IBUS	0
+			PPM_IBUS	1
+			PWM_SBUS	2
+			PPM_SBUS	3
    Power value => 0x80	0=High/1=Low
   Stream[3]   = option_protocol;
    option_protocol value is -127..127

Multiprotocol/Validate.h

@@ -72,6 +72,7 @@
 	#undef DSM_TELEMETRY	
 	#undef SPORT_TELEMETRY	
 	#undef HUB_TELEMETRY
+	#undef AFHDS2A_TELEMETRY
 #else
 	#if not defined(DSM_CYRF6936_INO)
 		#undef DSM_TELEMETRY
@@ -82,7 +83,10 @@
 	#if not defined(FRSKYX_CC2500_INO)
 		#undef SPORT_TELEMETRY
 	#endif
-	#if not defined(DSM_TELEMETRY) && not defined(HUB_TELEMETRY) && not defined(SPORT_TELEMETRY)
+	#if not defined(AFHDS2A_A7105_INO)
+		#undef 	AFHDS2A_TELEMETRY
+	#endif
+	#if not defined(DSM_TELEMETRY) && not defined(HUB_TELEMETRY) && not defined(SPORT_TELEMETRY) && not defined(AFHDS2A_TELEMETRY)
 		#undef TELEMETRY
 		#undef INVERT_TELEMETRY
 	#endif

Multiprotocol/_Config.h

@@ -22,7 +22,9 @@
 /********************/
 //Uncomment one of the line below if you have a different module not based on the original Multi Atmega328p design which includes the 4-in-1.
 //If you don't know then leave them commented.
-//#define STM32_BOARD
+#ifdef __arm__
+	#define STM32_BOARD	// Let's automatically select this board if arm is selected since this is the only one for now...
+#endif
 
 
 /*******************/
@@ -257,7 +259,10 @@ const PPM_Parameters PPM_prot[15]=	{
 		FORMAT_JJRCX1
 		FORMAT_X5C1
 	MODE_AFHDS2A
-		NONE
+		PWM_IBUS
+		PPM_IBUS
+		PWM_SBUS
+		PPM_SBUS
 */
 
 // RX_Num is used for model match. Using RX_Num	values different for each receiver will prevent starting a model with the false config loaded...