From 37c7167128034fd16a1bc83f038e77f52f281e69 Mon Sep 17 00:00:00 2001 From: pascallanger Date: Wed, 25 Jan 2017 15:09:44 +0100 Subject: [PATCH] Update Module_BG_4-in-1.md --- docs/Module_BG_4-in-1.md | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) diff --git a/docs/Module_BG_4-in-1.md b/docs/Module_BG_4-in-1.md index 1e0088a..ab5685d 100644 --- a/docs/Module_BG_4-in-1.md +++ b/docs/Module_BG_4-in-1.md @@ -30,9 +30,9 @@ If you are only planning on using the PPM interface with your transmitter, you n Some radios have an open collector output (Futaba, Graupner...), in this case you should add a 4.7K resistor between PPM and BATT. -This is valid for any version of the module. +The same plug is available on all versions of the module with the same signal locations. -You are now ready to go over to [Compiling and Programming](Compiling.md). +If you wish to add an external device reading the telemetry, you need to enable serial mode as explained in the next topics otherwise you are now ready to go over to [Compiling and Programming](Compiling.md). ###Serial mode If you have a transmitter that can support serial communication with the board then you need to wire up the board appropriately. There are three versions of the module and the steps are slightly different.