gomaomao/DIY-Multiprotocol-TX-Module
1
0
Fork 0
mirror of https://github.com/pascallanger/DIY-Multiprotocol-TX-Module.git synced 2025-02-04 21:58:10 +00:00
Code Issues Projects Releases Wiki Activity

Blinking patterns

Browse Source
This commit is contained in:
pascallanger 2016-11-17 12:55:30 +01:00 committed by GitHub
parent 7c22110c96
commit 34262a45ca
1 changed files with 7 additions and 5 deletions
Show Stats Download Patch File Download Diff File Expand all files Collapse all files

12
docs/Troubleshooting.md
View File

@ -9,18 +9,20 @@
- Off: program not running or a protocol selected with the associated module not installed - Off: program not running or a protocol selected with the associated module not installed
- Flash(on=0.1s,off=1s): invalid protocol selected (excluded from compilation or invalid protocol number) - Flash(on=0.1s,off=1s): invalid protocol selected (excluded from compilation or invalid protocol number)
- Fast blink(on=0.1s,off=0.1s): bind in progress - Fast blink(on=0.1s,off=0.1s): bind in progress
- Slow blink(on=0.5s,off=0.5s): serial has been selected but no valid signal has been seen on the RX pin. - Slow blink(on=0.5s,off=0.5s): serial has been selected but no valid signal is being seen on the RX pin.
- Slower blink(on=1s,off=1s): PPM has been selected but no valid signal is being seen on the PPM pin.
- On: Module is in normal operation mode (transmitting control signals). - On: Module is in normal operation mode (transmitting control signals).
##Protocol selection ##Protocol selection
###Input Mode - PPM ###Input Mode - PPM
- The protocol/mode selection must be done before the power is applied - The protocol/mode selection must be done before the power is applied to the module
- Check the Green LED to see when power is applied. Often power is not applied to the module until the transmitter has performed safety checks (like switch and throttle position settings) - Often the signal is not sent to the module until the transmitter has performed safety checks (like switch and throttle position settings)
- Check that at least one of the protocal selection to GND. - Check that at least one of the protocol selection pins is connected to GND.
###Input Mode - Serial ###Input Mode - Serial
- Make sure you have done the mods to the v2.3c PCB by adding the 2.2k and 470 ohm resistors as indicated in the [hardware page for your board] (Hardware.md). - Make sure you have done the serial mods as indicated in the [hardware page for your board] (Hardware.md).
- Protocol selection dial must be in the 0 position or leave all 4 selection pins unconnected. - Protocol selection dial must be in the 0 position or leave all 4 selection pins unconnected.
- Often the signal is not sent to the module until the transmitter has performed safety checks (like switch and throttle position settings)
##Bind ##Bind
Make sure to follow this procedure: press the bind button, apply power and then release after the red LED starts flashing. The LED should be blinking fast indicating a bind status and then fixed on when the bind period is over. It's normal that the LED turns off when you press the bind button, this behavior is not controlled by the Atmega328. Make sure to follow this procedure: press the bind button, apply power and then release after the red LED starts flashing. The LED should be blinking fast indicating a bind status and then fixed on when the bind period is over. It's normal that the LED turns off when you press the bind button, this behavior is not controlled by the Atmega328.