gomaomao/DIY-Multiprotocol-TX-Module
1
0
Fork 0
mirror of https://github.com/pascallanger/DIY-Multiprotocol-TX-Module.git synced 2025-02-04 21:08:12 +00:00
Code Issues Projects Releases Wiki Activity

Update PPM_Setup.md

Browse Source
This commit is contained in:
gerrievanzyl 2016-09-22 22:25:22 +02:00 committed by GitHub
parent 06ff17ebb2
commit 2cb9a7c199
1 changed files with 3 additions and 2 deletions
Show Stats Download Patch File Download Diff File Expand all files Collapse all files

3
docs/PPM_Setup.md
View File

@ -8,6 +8,7 @@ If you do not have a module bay, there are only three wires you need to connect
- PPM on pin 1
- vbat on pin 3
- ground on pin 4
Note: vbat should be between 6V and 13V when using the 4-in-1 and 2.3 PCB boards. If you built a module from scratch it depends on the voltage regulator you chose.
@ -22,7 +23,7 @@ Note: vbat should be between 6V and 13V when using the 4-in-1 and 2.3 PCB boards
To select the protocol simply switch off the transmitter and rotate the protocol selection switch on the module to the desired position.
*Note that the dial selection must be done before the module receives power - this is not necessarily the same time that the transmitter is powered up. The transmitter often only provides power to the module once it has passed switch checks and throttle position checks. *
**Note that the dial selection must be done before the module receives power - this is not necessarily the same time that the transmitter is powered up. The transmitter often only provides power to the module once it has passed switch checks and throttle position checks.**
The default mapping of protocols to switch positions can be viewed on the Protocol Details page found [here](Protocol_Details.md#DefaultMapping)