gomaomao/DIY-Multiprotocol-TX-Module
1
0
Fork 0
mirror of https://github.com/pascallanger/DIY-Multiprotocol-TX-Module.git synced 2025-02-04 21:58:10 +00:00
Code Issues Projects Releases Wiki Activity

Update Troubleshooting.md

Browse Source
This commit is contained in:
pascallanger 2017-01-25 15:50:07 +01:00 committed by GitHub
parent a6f8fe4c95
commit 2bbf672094
1 changed files with 1 additions and 0 deletions
Show Stats Download Patch File Download Diff File Expand all files Collapse all files

1
docs/Troubleshooting.md
View File

@ -18,6 +18,7 @@
- The protocol/mode selection must be done before the power is applied to the module - The protocol/mode selection must be done before the power is applied to the module
- Often the signal is not sent to the module until the transmitter has performed safety checks (like switch and throttle position settings) - Often the signal is not sent to the module until the transmitter has performed safety checks (like switch and throttle position settings)
- Check that at least one of the protocol selection pins is connected to GND. - Check that at least one of the protocol selection pins is connected to GND.
- Some radios have an open collector output (Futaba, Graupner...), in this case add a 4.7K resistor between PPM and BATT.
###Input Mode - Serial ###Input Mode - Serial
- Make sure you have done the serial mods as indicated in the [hardware page for your board] (Hardware.md). - Make sure you have done the serial mods as indicated in the [hardware page for your board] (Hardware.md).