DIY-Multiprotocol-TX-Module/docs/Models.md

#Model Setup
This is the page to document model or receiver specific setup instructions.

The Deviation project (on which this project was based) have a useful list of models [here](http://www.deviationtx.com/wiki/supported_models).

#Syma X5C
<img src="http://img2.cheapdrone.co.uk/images/upload/2014/12/X5C%203/SKU115108-7.jpg" Width="200" Height="200" />
##Channel Map
CH1|CH2|CH3|CH4|CH5|CH6|CH7|CH8
---|---|---|---|---|---|---|---
A|E|T|R|FLIP|RATES|PICTURE|VIDEO
##Binding
There are no special binding instructions.  The model powers up in Autobind mode and expects the bind sequence from the transmitter within the first 4-5 seconds. 
##Tx Setup
A basic 4-channel setup works perfectly, but some improvements are possible:   
###Setting up a switch to Flip   

###Setting up a swich for high rates

1. Choose your "Rates" switch
1. In the Mixer create an entry for CH6
1. Edit this line as follows:  
   - er9X: Source: FULL, Switch: THR (or whatever switch you selected)
   - OpenTx: Source: SF   

When the switch is in the rear position the rates will be standard, when the switch is forward rates will be high.  There is no need to move the throttle stick to the full up and full down position as with the standard controller. 

###Setting up Idle-up
One of the most annoying functions on the Syma X5C is that the motors stop when the throttle is pulled back.  This can be fixed by implmenting Idle-up on the transmitter (think of this as a very simple version of the Betaflight "Air Mode").  Idle up will ensure that even when the throttle is all the way down, a minimum command is passed to the motor to keep them spinning and to activate the stabilization.  

**To do this**:   

1. Decide on a switch you will use to activate Idle up
1. In the mixer menu add a line under Throttle and mix in a value of between 4 and 6 to be added to the throttle value if the switch is activated.  What this does is effectively prevents the throttle from going down to less than this value.
1. When you want to fly in "idle-up" mode flick the switch and your stabilization will always be active.  
1. Remeber to switch off idle-up as soon as the quad lands (or crashes - to avoid damage to the motors)

#Inductrix (Horizon Hobby)

<img src="https://s7d5.scene7.com/is/image/horizonhobby/BLH8700_a0" Width="200" Height="200" />

##Binding
{Enter bind instructions here - Which DSM mode works best?}

##Tx Setup
{How to setup the transmitter optimally for leveling and acro mode}